Loading ...
Loading ...
Loading ...
6. Put another' hex nut on each of the leveling
feet and hand-tighten until they are against
the leg_
Upper Stiffener
Bolt
Leg
10. Adjust the lower nut with the 9/16 inch
wrench until the leveling foot is at the desired
height.
11. Tighten the top nut by hand.
12. Repeat steps 8-1 t for the other' three lev-
eling feet if necessary.
13. Tighten all four bottom nuts using a 9/16
inch wrench°
Lockwasher Hex Nuts
Hex Nut Lower Stiffener /_
Leveling Foot
F/go33
Attaching Handwheel
Both Models
1. Place the handwheel on the front of the
saw. The front of the saw has a D-shaft that
fits into a D-slot in the handwheeL
WARNING: Saw blade can roll for-
ward toward you if the leveling feet are
not correctly adjusted. Workpiece or
saw can move unexpectedly if cabinet
rocks. Fingers, hand, or arm can be cut
off from blade contact. Adjust leveling
feet before using your saw.
2. Attach the handwheel using a screw and
extemat lockwasher. (Figures 34 &35 )
7. If the leveling feet raise the front of the
saw slightly higher than the rear, and if the
leg set does not rock, go to step 13, or
If the leveling feet do not raise the front of the
saw slightly higher than the rear, go to step 8,
OF
Handwheel
if the leg set rocks, go to step 8.
8. Loosen the bottom hex nut on the desired
leveling foot using a 9/16 inch wrench.
9. Loosen the top nut by hand.
Fig. 34
Fig. 35 - Screw and Extemal Lockwashet
16
Loading ...
Loading ...
Loading ...