Loading ...
Loading ...
Loading ...
17
W415-0847 / B / 03.17.11
A. Turn off the electrical and gas supply to the appliance.
B. Remove the frame from the appliance by removing the 2 stainless
steel hex head securing screws from the bottom and lifting the
frame off of the top trim bracket.
C. Lay the frame down on its front, being careful not to scratch the
fi nish.
D. Starting at the top of the frame, take one light assembly and
carefully snap it into place in the hole provided. Repeat for each of
the light assemblies. The wires on the top 2 light assemblies will
need to be fed in behind the heat shields.
NOTE: When installing the light kit be careful not to scratch
your fi ngers on any of the exposed screws in the frame.
E. Connect the light assemblies to the appropriate fl ags on the wire
harness. The wire harness is labeled (TR) top right, (BR) bottom
right (TL) Top left and (BL) bottom left.
F. Secure the wires into the clips at both sides and the bottom of the
frame. Use the extra clips provided to retain any loose wires.
G. Re-attach frame onto appliance.
H. Open the control panel door, leave the wires connected to the
ON/OFF switch and place the transformer into the bottom of the
appliance. Plug the transformer into the receptacle.
I. Attach one of the wire leads from the transformer to the lead on
the wire harness labeled “TRANS”, and the other to the ON/OFF
switch. Attach the last lead on the wire harness labeled “SWI” to
the ON/OFF switch.
J. Close the control panel door.
K. Turn on the gas supply and electrical power.
5.6 LK8 LIGHT INSTALLATION (OPTIONAL)
TR
TL
TRANS
SWI
CLIPS X 5
BR
BL
Loading ...
Loading ...
Loading ...