Loading ...
Loading ...
Loading ...
13
W415-0847 / B / 03.17.11
2
4
3
KEYHOLE
INSTALLATION
TEMPLATE
TORCH
MOUNTING
FRAME
CABINET
1
MOUNTING
BRACKET
DEFLECTOR
A. Using the installation template (W122-0401)
supplied, determine the best mounting location for
your new Torch, see “DIMENSIONS” or “MINIMUM
CLEARANCE TO COMBUSTIBLES” section. Mark
all 14 hole centres on the wall (surface) using the
template.
B. Align the holes on the defl ector with the holes on
the back of the torch as illustrated. Secure with the
appropriate fasteners.
C. Remove the template. Depending on the surface
and fasteners, drill the appropriate holes. Hold the
Torch up, aligning the mounting brackets to the
mounting holes. Secure the Torch to the wall using
the appropriate fasteners.
NOTE: The Torch has been designed to have a
1/2” clearance between the rear outer panel and
the mounting surface.
D. Start the fasteners into each of the six remaining
mounting holes. Align the keyholes of the frame
to the heads of the fasteners and slide the frame
down onto the fasteners. Ensure the frame is
plumb and level before tightening the fasteners.
NOTE: It is recommended that the gas and
electrical be connected to the appliance at this stage. Both must enter the appliance at the opening
created between the bottom of the Torch and the bottom of the mounting frame.
E. Slide the front of the cabinet over the mounting frame, ensuring the “mesh” is to the top. Start each of the four
screws (supplied) through the slots. Once the cabinet has been adjusted
for depth the four screws can
be tightened.
DEFLECTOR MUST BE INSTALLED.
!
WARNING
5.0 FINISHING
5.1 MOUNTING CABINET INSTALLATION
Loading ...
Loading ...
Loading ...