Loading ...
Loading ...
Loading ...
15
W415-0847 / B / 03.17.11
5.3 FRAME INSTALLATION
CONTROL DOOR
BOTTOM
TRIM
BRACKET
W385-0479
W
385-
0
479
A. Align the two
holes in the upper
portion of the hinge
on the control door to
those in the bottom trim
bracket, secure using
two of the #8 x 1/2” hex
head screws supplied.
B. Install the top trim
bracket to the fi rebox
using the three #9 - 14 x
1/2” hex head screws supplied in the
manual baggie.
C. Rest the top lip of the frame on the top trim bracket,
and the securing tabs at the bottom of the frame on
the bottom trim bracket.
D. Align the two slots in the top of the frame with the
two holes in the top trim bracket and secure using the two
#10 pan head screws supplied however do not fully tighten to
leave room for adjustment.
E. Align the holes in the securing tabs at the bottom of the
frame with the holes in the bottom trim bracket and
secure using the two remaining #8 x 1/2” hex head screws,
however do not fully tighten to leave room for adjustment.
F. If required, the bottom trim bracket can be adjusted by
loosening it’s securing screws.
G. Once the frame is perfectly square and the control door will
close without rubbing against the sides of the frame, tighten all
screws.
H. Open the control door.
I. Insert the door stop chain into the receiving slot in the control door.
J. Insert the door stop chain into the receiving slot in the frame
so that when fully open the control door has a clearance of 1/8” to the
fi nished wall. NOTE: In most cases, a count of 9 balls between
receiving slots will give the desired clearance.
K. Close the control door.
The frame has been designed to ac-
commodate fi nished material thicknesses of .500”
- .750”. If it is necessary to pull the frame
out to the max. .750” the magnetic catch will need
to be adjusted. Minor adjustment can be made by
removing shims from behind the magnet. Major
adjustments can be made by moving the magnet to
the outside of the panel.
Adjustment may be required to accommodate the door
stop chain slack when the control door is closed. The
control door securing screws can be loosened to allow adjust-
ment. Before re-tightening the screws ensure the control door is still
recessed into the frame at a similar offset to the top trim piece.
RECEIVING
SLOTS
DOOR
STOP
CHAIN
FRAME
TOP
TRIM
BRACKET
BOTTOM
TRIM
BRACKET
W385-0479
Loading ...
Loading ...
Loading ...