Loading ...
Loading ...
Loading ...
It is recommended to empty the purified water tank before using the system if the
system doesn’t been used for a period of time.
Press the “ ” and “ ” filter life reset buttons for 3 seconds, the system will
enter the drain mode after a beep and the “ ” indicator light will flash constantly.
Place a container (>51 oz) below the spout. Press the “ ” button to get water and
press it again to stop. The drain mode will be end after the purified water tank is
empty and the “ ” indicator light stops flashing. The screen displays a count-
down of 99 seconds to filter water again. The filtered water is drinkable after the flush
process. If the filtered water still tastes weird, it is recommended to empty the
purified water tank again.
● Manual flushing: Because the machine
has not been used for a long time, the water
stored in the purified water tank should be
drained and replaced with fresh water before
use. After that, the “ ” indicator light will
flash constantly. Place a container (>51 oz)
below the spout. Press the “ ” button to
get water for flushing until the “ ”
indicator light goes out before the water is
drinkable.
1. Filter life reminder
a. CF: Pre-Sediment and Carbon Block Filter
Service life: 6 months
b. MRO: Multiple Reverse Osmosis Membrane Filter
Service life: 18 months
Note: A total of 102 oz of water must be discharged. The whole operation takes
about 8 minutes. The water dispensed during flushing is not drinkable.
>51 oz
Section 4: Empty the Purified Water Tank
Section 5: Filter Life Reminder and Replacement Guide
[ ]
Figure 1.9
[ ]
Figure 1.9
Start
/ Off
Flush
Flush
Start
/ Off
Flush
Flush
MRO
Loading ...
Loading ...
Loading ...