Loading ...
Loading ...
Loading ...
Washcycletimeis
increased.
Determing the Problem
Problem Possible cause(s) Solution(s)
Washer door cannot be Child lock is activated. Deactivated Child lock (touch and hold Temperature
opened, and Finish in for approximately 3 seconds).
A power failure occured. If a cycle is interrupted by a power failure, it will
resume when the power is restored.
Cycle is running, or water level is Wait until the cycle ends.
too high and/or too hot.
Electric power cord has become Make sure the electric cord is securely plugged in.
loose or unplugged.
Program selector turned to Off Turn the program selector to a cycle.
before end of cycle.
Emergency door lock released is --> Emergency door lock release; Page 30
activated.
Door still cannot be Child lock is activated Deactivated Child lock (touch and hold Temperature
opened, even after and Finish in for approximately 3 seconds).
turning the washer Off Door is locked for safety reasons
and back on again. (high water level, temperature of
water hot, or high drum speed
(drum is turning).
Your washer utilizes sensors to
monitor certain characteristics of
the wash load. Increases in wash
cycle time could be due to:
Excess suds. _ displays at end of
cycle.
The automatic unbalanced load
detection system spins the laundry
several times to ensure even distri-
bution.
Cycle does not start - Start/Pause button not touched / Touch the Start/Pause button to start the cycle.
Start/Pause flashes, selected?
Washer door is not closed properly. Check if laundry is caught in the door. Close the door
until a click is heard, the cycle should start.
Cycle does not start - Cycle ending time has been Wash cycle will begin at proper time to complete at
Finish in-Time is dis- selected and activated, the selected finish time.
played.
Cycle does not start - Child lock is activated. Deactivate Child lock (touch and hold Temperature
o= symbol flashes, and Finish in for approximately 3 seconds).
Detergent residue Dry detergent may have been damp Clean and dry the detergent dispenser.
remains in the deter- or lumpy.
gent dispenser. Excess liquid detergent may have See Adding the correct amount of HE detergent to
been added, determine proper detergent usage.
Use the dosing cup for liquid deter- Clean and dry the detergent dispenser.
gent when dosing powder deter-
gent. Powder detergent may have
been damp or lumpy.
Water does not appear Start/Pause selected? Select Start/Pause.
to be coming into the Water taps not turned on. Turn on water taps.
washer, or detergent is
Supply hose kinked or pinched Eliminate the cause.
not washed away. (reduce flow).
Water supply hose strainers Clean the water inlet strainers.
clogged.
Water pressure too low. Eliminate the cause.
Water cannot be seen The water level in your high effi- No action needed.
in the drum. ciencey front load washer is below
the visible part of the drum, this is
normal.
Solutions are based on the specific reason the wash
time has been extended.
Use less detergent.
Always load the washer with a mixture of large and
small wash items (easier to distribute in the drum).
31
Loading ...
Loading ...
Loading ...