Loading ...
Loading ...
Loading ...
Thewatersupplypressuremustbe between14,5 to
145 psi (1 - 10 bar) with a minimum of 2.2 U.S. gallons
(8 liters) of flow per minute. A pressure regulator valve
must be installed if the maximum water pressure is
exceeded.
o Make sure the water supply faucet is easily accessible
when the washer is in use. The faucet should be
turned off if the washer is going to be unused for
extended periods of time.
o Make sure rubber washers are in place at both ends of
the water supply hose. Missing washers could cause
leaks.
o The connection points are under full water pressure.
Turn on the water tap and check for leaks.
o Periodically inspect the water supply hose and replace
with a new hose if cuts, kinks or leaks are observed.
Water drain hose connection
NOTICES
o Do not reuse an old drain hose. Only use the drain
hose and parts included with your washer.
o Do not kink or modify the water drain hose.
Height of drain point
Height difference between the floor and drainage point:
max. 39 in. (100 cm).
Types of drainage hookups
Standpipe
Water connection hoses
o red - Hot water-hose
o blue - Cold water-hose
Attach this end to water tap. Hand tighten only.
Attach the drain hose to the elbow included with your
washer.
Position the elbow on the drain hose 4" from end of hose
as shown. Insert this section of the drain hose into the
drain pipe. Secure the elbow and hose with a nylon tie
strap or the equivalent to keep the hose from coming out
of the drain pipe during use.
Sink siphon
...........
Secure the drain hose to the sink siphon using a O 0.9 -
1.6 in. (20-44 mm) hose clip (available from a hardware
store).
Attach this end of the hose to the back of the washing
machine. Hand tighten only.
14
Loading ...
Loading ...
Loading ...