Loading ...
Loading ...
Loading ...
Cycle end
End appears in the display field and the Start/Pause
button indicator lamp is off.
If this symbol _ appears in the display, the washer has
detected too much foam and it automatically adds an
additional rinse to remove the foam.
NOTICE: Use less detergent the next time you run the
washer with the same load.
Removing laundry/switching the
appliance off
1. Open the front door of the washer and remove the
laundry.
2. Turn the cycle selector to the Off position. Appliance is
switched off.
3. Turn off the water tap.
NOTICES
o Do not leave any laundry in the drum. It can shrink or
become discolored by the next laundry.
o Remove any remaining items from the drum and
rubber gasket.
o Leave the front door and detergent drawer open so
that any remaining water can dry.
o Always wait for the end of the cycle; otherwise the
appliance may still be locked. If locked, switch the
appliance on and wait until it unlocks.
o If at the end of the cycle the display is not lit up, the
energy saving mode is active. To see display, Touch
any button.
Signal
You can change the following settings:
o volume for button signals
o volume for indicator signals
To change these settings always activate adjustment
mode first.
Off
--1
2
--3
__/ i
© A
0=off, l=soft, 2=
mid, 3 = loud, 4 =
very loud
Quit adjustment mode
Turn the Cycle Selector to Off position. The settings were
saved.
Activate adjustment mode
1. Select Cotton Normal on Position 1.
The appliance is on.
2. Hold down Start/Pause and turn the Program Selector
to the right (Position 2). Release Start/Pause button.
Adjustment mode is now activated and the default
volume for indicator signals appears in the display.
Changing the volume
You can set the volume by touching the Finish in button
with the program selector in one of the following
positions:
o Position 2: for indicator volume
o Position 3: for button signals volume
22
Loading ...
Loading ...
Loading ...