Loading ...
Loading ...
Loading ...
page 4
Remove single motor mounting screw
from hook end of motor assembly. Remove
2 motor mounting screws from hanging
bracket.
Lift motor assembly to hanging bracket
and slide hook end (with single screw hole)
into square opening on hanging bracket
(see diagram at right). This will allow the
motor assembly to hang out of the way
while wiring.
Tip: Seek the help of another person to
hold the stepladder in place and to lift the
fan up to you once you are set on the
ladder.
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch
is turned to the OFF position.
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply
with Local Codes or Ordinances and the
National Electrical Code. If you are unfamiliar
with electrical wiring or if the house/building
wires are different colors than those referred
to below, please use a qualified electrician.
When fan is secured in place on the
hanging bracket, electrical wiring can be
made as follows:
Connect BLACK and BLUE wire from fan
to BLACK wire from ceiling with wire
connector provided.
Connect WHITE wire from fan to WHITE
wire from ceiling with wire connector
provided.
Connect all GROUND (GREEN) wires
together from fan to BARE/GREEN wire
from ceiling with wire connector provided.
If you intend to control the fan light with a
separate light switch, connect BLUE wire from
fan to the BLACK (or RED) supply from the
independent switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
5. Preparation for Wiring.
6. Wiring.
hanging
bracket
motor assembly
motor
mounting
screws
wire
connector
hanging
bracket
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GROUND (GREEN OR BARE) GREEN
wire
connectors
from ceiling
from fan
hook
end
Loading ...
Loading ...
Loading ...