Loading ...
Loading ...
Loading ...
4. Hanging Bracket Installation.
Turn off circuit breakers to current fixture from
breaker panel and be sure operating light switch
is turned to the OFF position.
WARNING: Failure to disconnect power supply prior
to installation may result in serious injury.
Remove existing fixture.
WARNING: When using an existing outlet box, be
sure the outlet box is securely attached to the
building structure and can support the full weight
of the fan. Ensure it is clearly marked "Suitable for
Fan Support." If not, it must be replaced with an
approved outlet box. Failure to do so can result in
serious injury.
CAUTION: Be sure oulet box is grounded properly
and that a ground wire (GREEN or bare) is present.
Install hanging bracket to outlet box using
original screws, spring washers and flat washers
provided with new or original outlet box.*
Arrange electrical wiring to one side of the
hanging bracket.
*Note: It is very important that you use the proper
hardware when installing the hanging bracket as
this will support the fan.
page 3
hanging
bracket
spring washers
ON
OFF
ON
OFF
3. Installation Preparation.
To prevent personal injury and damage, ensure
that the hanging location allows the blades a
clearance of 7 feet (2.13m) from the floor and
30in. (76cm) from any wall or obstruction.
This fan is suitable for room sizes up to
100 square feet (9.3 square meters).
This fan can be mounted as a flushmount only
on a regular ceiling. Downrod installations are
not available for this fan.
Installation requires these tools:
Phillips screwdriver, flathead screwdriver,
adjustable pliers or wrench, stepladder, wire
cutters, and rated electrical tape.
downrod
installation
flushmount
installation
outlet box screws
8ft. - 10ft.
8ft. - 10ft.
(2.42m - 3.05m)
blade edge
7 feet
(2.13m)
(76cm)
30
inches
flat washers
(2.42m - 3.05m)
CANNOT be
installed on
angled or
vaulted ceilings
Loading ...
Loading ...
Loading ...