Loading ...
Loading ...
Loading ...
NAMES OF OVEN PARTS AND ACCESSORIES
Remove the oven and all materials from the carton.
Your oven comes with the following accessories:
Turntable/Turntable roller rest/Use and Care Guide
Super EvenWave ® System
The microwaves reach the embossments on the interiorwalls
and then bounce in every direction. As a result, microwave
energy will be reflected from many angles to cook and defrost
more evenly and result in improved performance.
Safety interlock system
Shuts off oven power if
door is opened
during operation.
Door
Interior light
\
° o o o _
o o • e o o
o o
° ° o o ° °
Control panel
Door Handle
When you open the
door while cooking is in
progress, the cooking stops
but the program will not be
canceled. Close door and
press START to resume
cooking,
TURNTABLE INSTALLATION
• Place the roller rest on the cavity CAUTION: The inside of the oven and
bottom, turntable get very hot, so do not touch
• Turntable hub should securely locked them immediately after use.
in the receptacle. Never place the
turntable upside down. Turntable Hub (underside)
• The turntable rotation should never
be restricted.
• Place the turntable on top ofthe roller
rest as shown in the diagram.
• Both turntable and roller rest must
always be used during cooking.
• All food and containers of food are
always placed on this turntable for
cooking. _,
° This turntable rotates clockwise or Roller rest _ Receptacle
counterclockwise; this is normal.
INSTALLATION
This oven is designed for Countertop or Built-in installation. Before you begin
installation, you need to decide how you should install your oven.
Remove all packing material and accessories. Examine the oven for any damage
such as dents or broken door. Do not install if oven is damaged.
I Countertop Installation
1. Select a level surface that provides
enough open space for the intake
and/or outlet vents.
• Leave a minimum clearance of
3 inches around the oven. One side
must be open.
J Built-In Installation
• Leave a minimum clearance of
3 inches above the oven.
• Do not remove the legs from the
bottom of the oven.
• Blockingthe intake and/or outlet
openings can damage the oven.
2. Plug your oven into a standard 120-
volt / 60-Hz household outlet. Be
sure the electrical circuit is at least
15 amperes and that your
microwave oven is the only
appliance on the circuit.
WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance. If installed near orover a heat
source,the oven could be damaged and
the warranty would be void.
It is necessary for you to purchase an
Optional Kit for Built-in Installation.
Contact the store where you purchased
tour oven for an optional Built-in Kit.
Model No. Built-inKit Stock No.
565.61582 (27inch)20-6911
(White) (30inch)20-6913
565. 61584 (27inch)20-6914
(Bisque) (30inch)20-6915
565.61589 (27inch)20-69910
(Black) (30inch)20-69912
When installing in a Built-in situation,
the oven requires an opening for
installation.
(27 inch): 25"(w) x 17"(h) x 21"(d)
(30 inch): 28-1/2"(w) x 17"(h) x 21"(d)
Do not remove the legs from the
bottom of the oven.
• Plug your oven into a standard 120-
volt / 60-Hz household outlet. Be sure
the electrical circuit is at least 15
amperes and that your microwave
oven is the only appliance on the
circuit. 2
WARNING: If installing the microwave
oven over an electric oven, it must only
be installed over the following Kenmore
Electric Ovens, Stock No.:
(27 inch) 47485, 47486, 47489, 47189 _i
(30 inch) 41785, 41789, 41085, 41086
If installed over any otherthan the listed
Electric ovens, the microwave could be
damaged and the warranty would be
void.
Blocking the intake and/or outlet
openings can damage the oven.
The trim must not interfere with
adjacent appliance or cabinet
surfaces. To prevent interference,
leave the clearances listed below at
the front of the microwave opening.
Left and Right sides: 1 inch
Top and Bottom sides: 2 inches
Loading ...
Loading ...
Loading ...