Loading ...
Loading ...
Loading ...
4
INSTALLATION INSTRUCTIONS
CUSTOM PANEL INSTALLATION
8. Open the Microwave Drawer door and pre-drill each hole
using a
1
/16" drill bit. Fasten the unit to the mounting
cleats using the 4 mounting screws provided with your
Microwave Drawer. See Figure 9.
SIDE
RAIL
FIGURE 9
9. Install bottom kickplate. Use the 2 toe kick screws to
fasten the plate. See Figure 10.
*NOTE: PROVIDE FILLER IF NEEDED
SERIAL
NAMEPLATE
FIGURE 10
For any other assistance or information about this kit,
please call Sharp’s Customer Assistance Center:
1-800-BE-SHARP (1-800-237-4277)
SHARP ELECTRONICS CORPORATION
100 Paragon Drive • Montvale, New Jersey 07645
TINSEB573MRR
Oct 21, 2019
The Microwave Drawer pedestal drawer fronts can be
replaced with custom wood fronts. If custom drawer faces
are preferred, the stainless steel drawer faces can be
taken o by removing 5 screws (3 on the back side and 2
underneath). See Figure 11.
Suggested custom drawer face dimensions:
Height 6
3
/8"
Width 23
11
/16"
Depth 1"
FIGURE 11