Loading ...
Loading ...
Loading ...
Connect
the tubing to
water line
1. Unplug refrigerator ordisconnect power.
2.Turn OFF main water supply. Turn ON nearest faucet long enough to empty
water pipes.
3. Find a 1/2 -inch to 1-1/4 -inch vertical COLD water pipe near the refrigerator,
4. To determine the length of copper tubing you will need, measure from the
connection on the lower left rear of the refrigerator to the water pipe. Add 7
feet (2.1m)to allow for moving refrigerator for cleaning. Use 1/4 -inch O.D.
(outside diameter) copper tubing. Be sure both ends of copper tubing are cut
square.
5. Using a grounded drill, drill a 1/4 - inch hole in the cold water pipe you have
selected.
6. Fasten shut -off valve to cold water pipe with pipe clamp. Be sure outlet end
is solidly inthe 1/4dnch drilled hole in the water pipe and that the washer is
under the pipe clamp. Tighten packing nut. Tighten the pipe clamp screws
carefully and evenly so washer makes a watertight seal. Do not over tighten or
you may crush the copper tubing, especially if soft (coiled) copper tubing is
used. Now you are ready to connect the copper tubing.
7. Slip compression sleeve and compression nut on copper tubing as shown.
Insert end of tubing into outlet end squarely as far as it will go. Screw
compression nut onto outlet end with adjustable wrench. Do not over tighten.
8. Place the free end of the tubing into a container or sink, and turn ON main
water supply and flush out tubing until water is clear. Turn OFF shut- off valve
on the water pipe. Coil copper tubing.
Pipe
Packing Nut\
Coil of polyethylene or
Shut Off Valve Copper Tubing
Compression Sleeve Compression Nut
Loading ...
Loading ...
Loading ...