SET UP
READY TO SHARPEN!
INSTRUCTIONS
KNIFE SHARPENER
ANGLE SET
1
Open the carry case, rotate and remove the
lid. Use the left side cover as a hand guard.
CLOSED
OPEN TO 90°
SLIDE OUT
SERRATIONS
QUESTIONS?
Place the serration onto the ceramic rod so
that the serration nests onto the rod.
A. Using light pressure, slide the knife up
and down in short strokes.
B. Repeat until all serrations are sharpened.
1
Lay flat side of serration on ceramic rod and
swipe with light pressure until burr is removed.
Connect tapered ceramic rod to sharpener.
3
3
1
2
PLEASE LEAVE A REVIEW WHERE
YOU PURCHASED YOUR PRODUCT
2
Work Sharp® is a registered trademark of Darex, LLC
For Patent Info Visit: worksharptools.com/patents
Designed, calibrated and quality checked in
Ashland, OR using foreign components.
WorkSharpTools.com / 1.800.597.6170
Keep knife vertical when sharpening.
No water or oil is required.
Rotate both abrasive rods so that the coarse grit diamond abrasive is facing outward.
Hold knife vertical at top of abrasive rod, then use light pressure to slide edge from heel to tip.
Continue alternating strokes until a burr is formed (8-10 strokes).
Rotate abrasive rods to the medium grit diamond. Refine edge by alternating strokes (8-10 strokes).
Rotate abrasive rods to the fine grit ceramic. Refine edge by alternating strokes (8-10 strokes).
SHARPEN
PRO TIP
2
3
2
5
1
25° 20° 15°
1 7. 5 ° 22.5°
25°20°15°
25°
20°
15°
1 7. 5 °
22.5°
Select desired sharpening angle (15°, 17.5°, 20°, 22.5°, 25°).
3
4
Edge angle changes or chip repair will require
more strokes.
Not getting sharp? Be sure to raise a burr before
progressing to finer grits.
KITCHEN
15°
20°
EDC
25°
OUTDOOR
