Loading ...
Loading ...
Loading ...
29
Locate the Reed Switch (55) and the Magnet (41)
on the left side of the Pulley (42). Turn the Pulley
until the Magnet is aligned with the Reed Switch.
Make sure that the gap between the Magnet
and the Reed Switch is about 1/8 in. (3 mm). If
necessary, loosen the #8 x 3/4" Clamp Screw (20),
move the Reed Switch slightly, and then retighten
the Screw. Reattach the Left Roller Cover (not
shown) and run the incline trainer for a few minutes
to check for a correct speed reading.
SYMPTOM: The incline of the incline trainer does
not change correctly
a. Calibrate the incline system (see step 4 on page
24).
SYMPTOM: The walking belt slows when walked on
a. Use only a surge suppressor that meets all of the
specifications described on page 14.
b. If the walking belt is overtightened, incline trainer
performance may decrease and the walking belt
may become damaged. First, adjust the incline to
40 percent. Then, remove the key and UNPLUG
THE POWER CORD. Using the hex key, turn both
idler roller screws counterclockwise, 1/4 of a turn.
When the walking belt is properly tightened, you
should be able to lift each edge of the walking belt
3 to 4 in. (8 to 10 cm) off the walking platform. Be
careful to keep the walking belt centered. Then,
plug in the power cord, insert the key, and run the
incline trainer for a few minutes. Repeat until the
walking belt is properly tightened.
c. Your incline trainer features a walking belt coated
with high-performance lubricant. IMPORTANT:
Never apply silicone spray or other substances
to the walking belt or the walking platform un-
less instructed to do so by an authorized ser-
vice representative. Such substances may de-
teriorate the walking belt and cause excessive
wear. If you suspect that the walking belt needs
more lubricant, see the front cover of this manual.
d. If the walking belt still slows when walked on, see
the front cover of this manual.
42
41
1/8 in.
Top
View
20
3–4 in.
b
Idler Roller Screws
55
Loading ...
Loading ...
Loading ...