Loading ...
Loading ...
Loading ...
Installation and connection en
13
1.
Note:Check the technical specifications of the ap-
pliance and select the cavity dimensions corres-
ponding to the model.
Make a cut-out in the worktop, depending on the in-
stallation position.
The angle between the cut surface and the worktop
must be 90°.
2.
Ensure that the worktop has sufficient load-bearing
capacity and stability.
Use a heat- and humidity-resistant reinforcing mater-
ial for any substructure.
3.
Ensure that the fitted unit is still stable after the cut-
outs have been made.
4.
Remove any shavings.
12.7 Installing the appliance
▶
Lift the hob horizontally and slowly place it into the
opening in the worktop until the edge of the hob is
fully in contact with the worktop.
12.8 Connecting a non-metallic gas hose
Requirement:The gas hose must meet the require-
ments.
1.
Note:Please read the installation instructions for the
gas hose carefully and install in strict accordance
with the regulations.
Use the connection elbow and corresponding seal
to connect the appliance to the gas hose.
2.
Connect the other end of the gas hose to the gas
valve.
3.
The connection between the gas hose and gas
pipeline must be secured by a compression nut or
pipe clamp.
4.
Perform a gas leak test.
12.9 Gas leak test
Use soapy water to test for leaks
1.
Use a soft brush dipped in soapy water to coat the
connecting section of the gas pipeline.
2.
Open the gas valve and carefully observe whether
bubbles form.
If bubbles form, close the gas valve immediately.
3.
Adjust the leaking connecting section.
4.
Repeat the above steps until there are no air
bubbles on the connecting section.
12.10 Installing the battery
▶
The battery box is on the right side of the appliance
base. Install the D-sized battery in the battery box
correctly, paying attention to the positive and negat-
ive symbols.
Notes
¡ Use high-energy alkaline batteries.
¡ Replace with a new battery when the hob becomes
difficult to ignite.
Loading ...
Loading ...
Loading ...