Loading ...
Loading ...
Loading ...
Owner's Manual
Installation (cont'd)
Supporting and Mounting
Mount the generator on a concrete slab capable of supporting the weight of the generator. The
slab must extend on all sides beyond the frame by at least one foot. Contact a cement contractor
for slab specifications if necessary. Attach the frame to the concrete slab using 3/8" diameter
expansion anchor bolts (not supplied).
Grounding
_ OTE: IT IS RECOMMENDED THAT ONLY A TRAINED AND MCENSED
ELECTRICIAN PERFORM THIS PROCEDURE
Connect a #6 AWG grounding wire (not included) from the ground connector on the
generator power panel (picture below) to a grounding rod (picture below). It must be driven
at least 24" deep into the earth (Soil). The grounding rod must be an earth-driven copper or
brass (electrode) which can adequately ground the generator.
Ground Connector
7500W Generator
Compliance
UNITED STATES ENVIRONMENTAL PROTECTION AGENCY,
WASHINGTON, DC 20460
2009 Model Year Certifcate of Conformity
• Manufacturer. Jiangsu Jiandong Group Co. Ltd.
oCertiflcate Number: JDG-NRSI-09-01
Effective Date: 1/6/2009
• Date Issued: 1/6/2009
Merrylin Zaw-Mon, Director, Compliance and Innovation Strategies Division, Office of
Transportation and Air Quality.
Pursuant to Section 213 of Clean Air Act (42 U.S.C. section 7547) and 40 CFR 90 and 40 CFR 60
(stationary only and combined stationary and mobile), and subject to the terms and conditions
prescribed in those provisions, this certificate of conformity is hereby issued for the following
small non-road engine family, more fully described in the documentation required by 40 CFR 90
and produced in the stated model year.
This certificate of conformity covers only those new small non-road engines which conform in
all material respects to the design specifications described in the documentation required by 40
CFR 90 and which are produced during the model year stated on this certificate. This certificate
of conformity does not cover small non-road engines imported prior to the effective date of the
certificate.SMALL NON-ROAD ENGINE FAMILY: 9JDGS.3892GA
This certificate of conformity is conditional upon compliance of said manufacturer with the
averaging, banking, and trading provisions of 40 CFR Part 90, Subpart C both during and after
model year production. Failure to comply with these provisions may render this certificate void ab
initio. The HC + NOX family emission limit (FEL) is: g/k W-hr.
It is a term of this certificate that the manufacturer shall consent to all inspections described in
40 CFR 90.126 and 90.506 and authorized in a warrant or court order. Failure to comply with the
requirements of such a warrant or court order may lead to revocation or suspension of this
certificate for reasons specified in 40 CFR Part 90. It is also a term of this certificate that this
certificate may be revoked or suspended or rendered void ab initio for other reasons specified
in 40 CFR Part 90.
This certificate does not cover small non-road engines sold, offered for sale, or introduced, or
delivered for introduction, into commerce in the U.S. prior to the effective date of the certificate.
27 28