Loading ...
Loading ...
Loading ...
Owner's Manual
Operation (cont'd)
Starting
4. Operate the Recoil Starter: Turn the key to the "Run" position.
Pull the starter grip lightly until you feel resistance,
then pull briskly. Return the starter grip gently.
Pulling the starter grip operates the recoil starter to
crank the engine.
ELECTRIC START. For Electric Start just turn the key to start.
NOTE: Make sure the adequate battery is installed correctly.
(see battery installation for details)
5. If the choke lever has been moved to the CLOSED
position to start the engine, gradually move it to the
OPEN position as the engine warms up.
Stopping Engine
1. Turn the engine switch to the OFF position.
2. Turn the fuel valve lever to the OFF position.
When the engine is not in use, leave the fuel valve lever in
the OFF position to prevent carburetor flooding and to
reduce the possibility of fuel leakage.
7500W Generator
Operation (cont'd)
Powering 120 Volt AC Tools And Equipment:
1. Prior to powering tools and equipment, make sure the generator's rated voltage, and
amperage capacity (120VAC) is adequate to supply all electrical loads that the unit will power.
If powering exceeds the generator's capacity, it may be necessary to group one or more
of the tools and/or equipment for connection to a separate generator.
2. Once the
tools and
CAUTION: ATTEMPTING TO POWER SENSiTiVE ELECTRONIC EQUIPMENT
WITHOUT THE USE OF AN APPROVED LiNE CONDiTiONER MAY CAUSE
DAMAGE TO THE EQUIPMENT. ALL-POWER IS NOT RESPONSIBLE
FOR ANY DIRECT OR iNDiRECT DAMAGE CAUSED BY FAILURE TO USE AN
APPROVED LiNE CONDiTiONER.
generator is running, simply connect the power cords of 120 volt AC powered
equipment into the 120 volt AC dual outlets.
NOTE: THE GENERATOR FEATURES AN AC NON-FUSE CiRCUiT BREAKER
TO PROTECT THE AC CiRCUiT iN CASE OF AN OVERLOAD. SHOULD
AN OVERLOAD OCCUR, THE BREAKER WiLL "TRIP" TO ITS "OFF" POSiTiON,
iN THIS CASE, REFER TO ABOVE iN THIS POSiTiON. THEN, RESET THE
CiRCUiTRY SYSTEM BY TURNING THE CiRCUiT BREAKER TO ITS "ON"
POSiTiON.
3. Disconnect all electrical powered tools and equipment from the generator's 120 volt AC
duel outlets.
4. After the engine and generator have completely cooled, store generator in a safe, clean, dry
location (if not already installed).
21 22
Loading ...
Loading ...
Loading ...