Loading ...
Loading ...
Loading ...
Owner's Manual
Assembly
Handle installation.
Start by installing the handle on the
frame with two 8ram bolts.
Then install the handle retainer as
shown.
Floor Mount installation
This generator has an option of not using the mobility kit.
If this is desired, just install the 4 rubber mounts on the
frame as shown. (this is why there are 6 mounts).
If you want to use the mobility kit, save the 4 mounts
in a safe place, and continue to the "mobility kit
installation." section.
7500W Generator
Assembly
Wheel Kit installation
Start by _nstalflng the Here is the hardware required to _nstafl
rubber floor mounts the support leg. Place a block of wood
onto the support leg under the generator so that you don't
as shown, have to hold it up wh_le trying to instafl
Note: The leg should the leg.
be instafled on the _; _{_ Place the support leg under the frame,
same side as the puff _ @ __ Push the bolt thru the frame and thru
handle, the leg, Thread a nut onto the bolt.
Tighten with a wrench.
This is what the leg
looks like when it is
installed.
The wheels should be installed on the side
opposite to the handle,
Place a block of wood under the
generator so that you don't have to hold it
up while trying to instafl the axle.
Push the two axle mount brackets onto
each side of the axe], Place the axle under
the unit,
Thread two bolts thru the tubular frame
and thru the axle mounting plates. Thread
a nut onto the bolt and tighten,
Slide the wheels
onto the axle. Place
a washer over the
wheel
Push the cotter pin thru
the axle and bend it
backwards as shown
Your generator _s now
mobile. Enjoy!
Here is a picture of the floor
mounts installed.
17 18
Loading ...
Loading ...
Loading ...