Loading ...
Loading ...
Loading ...
.
.
Remove and discard all packing
material from around the snow
thrower.
For shipping purposes, the height
adjust skids are attached to the
pallet. Remove the screw that se-
cures each height adjust skid to
the pallet. See Figure 3.
Hei(
Adjust
Skid
8. Cut the ties that secure the clutch
control cables to the lower handle.
See Figure 1. Move the cables
away from the motor frame.
9. Make sure the clutch control
cables are attached to the clutch
levers. See Figure 4.
10. Tighten the bolts that secure the
upper and lower handles.
Clutch Lever
.
Screw Figure 3
Loosen (,do not remove) the bolts
that fasten the upper and lower
handles. Raise the upper handle
into the operating position.
NOTE: Make sure the cables are
not caught between the upper
and lower handles.
\
Clutch Control Cable Figure 4
11. Hold onto the handle and pull the
snow thrower off the carton.
CAUTION: DO NOT back over
cables.
How To Assemble
The Handle And Crank Assembly
1. Loosen, but do not remove, the fas-
teners in the upper holes of the
lower handle. See Figure 5.
. Install the screw, flatwasher, lock-
washer, and hex nut into the bot-
tom hole on the right side of the
handles. DO NOT tighten until all
fasteners are in place.
Crank
Assembly
F-001129J
Loosen, Do'_
Not Remove I
Eyebolt
Upper Handle
P
r /
_l_ Lower Handle ,,_
Locknut Nut 3/8
Flatwasher ,_
Lockwasher 318"/
Flatwasher 3/8"
8
/
Loosen, Do
_,# Not Remove
Flatwasher 3/8"
-_j Screw3/8" x 2'
Figure 5
Loading ...
Loading ...
Loading ...