Loading ...
Loading ...
Loading ...
Installation
*INSTALLATION*
58
Installation
Create the countertop cut-out. Re-
member to maintain the minimum
safety distances (see “Installation” –
“Safety distances”).
Seal any cut surfaces on wooden
countertops with a special varnish,
silicone rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be tem-
perature-resistant.
Ensure that the sealant does not get
on the top surface of the countertop.
Attach the sealing strip provided un-
derneath the edge of the cooktop. Do
not apply the sealing strip under ten-
sion.
Feed the cooktop power cord down
through the countertop cut-out.
Place the cooktop centrally in the
cut-out. When doing this make sure
that the seal of the appliance sits
flush with the countertop on all sides.
This is important to ensure an effec-
tive seal all round.
Do not use any additional sealant
(e.g.,silicone) on the cooktop.
If the seal does not sit flush with the
countertop in the corners, the corner
radius (≤R4) can be carefully cut to fit
using a jigsaw.
Connect the cooktop to the electrical
power supply.
Check that the cooktop works.
Loading ...
Loading ...
Loading ...