Loading ...
Loading ...
Loading ...
SEOT_O 2 HOW YOUR WATER SOFTENER WORKS
2A. FACE PLATE TIMER FEATURES
u u,,, i i ,,
EXTRA RECHARGE
Sometimes, a manually started regeneration (re-
charge) may be desired, or neede& Two examples
are:
--You have used more water than usual (guests
visiting) and you may run out of soft water before
the next timer started regeneration.
You did not refill the softener with salt before it
was gone.
You can start a regeneration right awa}; or you can
set the timer to regenerate at the next 2:00 AM (or
other preset recharge time), Do the following_
RECHARGE NOW
M PIess the ON/OFF-HOLD i°']_77t_p,,
button and hold until *RE- ,_C,A,G_
CHARGE, Serv and fill begin
to flash in the display, Upon __.__ ,, _,o.
reaching fill, the first cycle of
regeneration, the flashing Serv goes off and Fill is
on steady. RECHARGE continues to flash. This
regeneration will last for about 2 hours. After the
2 hours, you will have soft water again.
*NOTE:
If the CLEAN feature is set to ON, a cleaning
backwash (CLEAN and Bkwsh or Rinse flashes in
the display, along with the minutes of the clean
cycle remaining) precedes the recharge.
RECHARGE TONIGHT
[] Press and release (do not hold) the ON /
OFF-HOLD button. RECHARGE TONIGHT
flashes in the display, and the softener begins
regeneration at the next preset recharge time.
Press and release the ON/OFF-HOLD button
once more if you decide to [ :oq q,no..]
° 1 _,uo t
cancel the regeneration, and ! ._._._ON,G._
RECHARGE TONIGHT. , 1_ ]
SALT MONITOR SYSTEM
The face plate timer has a low salt monitor with an
indicator light to remind you to refill the storage
tank with sail To set this monitor system:
1. Lift the salt hole cover and level the salt in the
storage tank,.
2. The salt level decal, on the brinewetI inside the
tar&, has numbers from 0 to 8 (see drawing on
page 9 and below)_ Observe the number the
leveled saIt is at or closest to,
3_
Now, press the SALT LEVEL ADJUST button
until black bars display up to the salt level
number'. For example, the pictures below show
the salt leve! at 6.
41
FinaIly, set the level you want the low salt
indicator light to come on. Press the SIGNAL
LIGHT ADJUST button until a (_) shows
opposite this number. In the example below,
the light will come one when the stored salt
drops to level Z At level 2, the storage tank is
about 1/3 full. This is the lowest you should
allow the stored salt level to drop to. To turn the
salt monitor off, press the button until OFF
shows.
NOTE:
For accurate salt monitor operation, always use
nugget or pellet water softener salt. See page 9.
salt
levet
8 _
-i
bars, salt
level _ _ LEVEL
JUS3'
._- brinewell
_f decal 1 LIGHT
8
7
_6
f_15
'*IEf_ 4
_3
ItB2_
_l_
SA_
indicator tight
10
Loading ...
Loading ...
Loading ...