Loading ...
Loading ...
Loading ...
iSpring WDS Series Whole House Systems
Version 2020-05
Page 8
Maintenance Instructions
Your iSpring Whole House Water System requires care and cleaning after a period of time. It is
recommended that the cartridges be replaced every 6-12 months depending on the amount of
contaminants present in the water supply. If the system has been working properly and the
pressure is slowing, it may be time to change the filter cartridge.
Replacement cartridges and parts can be ordered online at www.123filter.com
or by calling 678-
261-7611.
Filter Change Instructions
Part 1- Remove the old cartridge
1.1 Turn off the water supply to the system. Open a nearby faucet to release the
pressure and drain the water.
Depress the pressure release button on the top of the filter housing to relieve system
pressure. This will make removing the filter housing easier.
1.2 Unscrew the housing using the filter wrench included (AWR3) with your system, or a
commercially available “strap” type wrench.
1.3 Locate and remove the large O-ring using a small, clean flat head screwdriver. Try
not to remove any of the lubricant. Set it aside in a clean, safe place.
1.4 Remove and discard the old filter cartridge.
Part 2- Clean the housings
2.1 Scrub the housing and cap with warm water mixed with about 2 tablespoons of
household bleach using a sponge or soft rag. Wear rubber gloves. Rinse all parts very
thoroughly!
2.2 Lubricate the O-ring with clean silicone grease if needed. DO NOT USE PETROLEUM
JELLY. Insert the O-ring in filter groove and press into place. Make sure the O-ring is
seated correctly.
CAUTION:
This step is important to ensure the proper filter seal. Make sure the O-rings (ORB) are
seated level in the groove. If the O-ring appears damaged, stretched, or crimped, it
should be replaced.
Part 3- Install the New Cartridge
Loading ...
Loading ...
Loading ...