Loading ...
Loading ...
Loading ...
The cooker MUST be installed in compliance with:
• wiring connections in AS/NZS 3000 Wiring Rules
• local regulations, municipal building codes and other
statutory regulations
• For New Zealand Only:
The cooking range must be connected to the supply by
a supply cord fitted with the appropriately rated plug
that is compatible with the socket-outlet tted to the nal
sub-circuit in the xed wiring that is intended to supply this
cooking range.
Data plate gives information about rating
is located behind the bottom of the oven
door
Circuit
diagram
is located on the back panel of the
appliance
• A functional switch MUST be provided near the appliance
in an accessible position (AS/NZS 3000 - Clause
4.3.11).
• Wiring MUST be protected against mechanical failure
(AS/NZS 3000 - Clause 3.9).
• The cooker requires a means of all pole disconnection
incorporated into the xed wiring. This MUST have a
disconnection gap of 3mm.
• The cooker MUST be properly earthed.
When connections are made to a multi-phase
230/240V supply, the bridge piece MUST be removed from
between the active connections.
TIPS & INFORMATION
Before you cook in your new oven it is important
that the protective oils used in the manufacture of the product
be removed.
• Make sure that the room is well ventilated (to allow smoke
to escape).
• Run the grill on high for 30 minutes without grill dish.
• Then run the oven on 220°C for 1 hour.
This appliance must be installed by an authorised person,
according to all codes and regulations of:
• Electrical supply authorities.
• Building regulations
• Local government and council authorities.
• AS5601/AG601 (particular attention to 5.12.1 and
gure 5.1 on page 90, 5.12.1.7).
• AS/NZS 3000 (particular attention to clause 4.3.11 and
clause 3.9).
1. Remove terminal cover plate from rear panel of appliance.
2. Fit wires through hole in cover plate and make connections
to terminals.
3. Engage wires into plastic clip. Secure plastic clip with two
long silver screws (supplied in separate bag).
4. Replace cover plate onto rear panel.
Rear view terminal block position
Plastic clips
Plastic clip
securing points
410mm to centre
of electrical panel
200mm to centre
of electrical panel
Loading ...
Loading ...
Loading ...