Loading ...
Loading ...
Loading ...
To ensure cooker stability, both the anti-tilt plate and
stability bolt MUST be installed on all cookers (electric and
gas).
1. The cooker is delivered with the anti-tilt plate. Locate the
anti-tilt plate against the rear wall. If locating between 2
cupboards, then t the plate in the centre of the space.
If locating the cooker at the end of a cupboard, then
position the side of the plate 48mm from the cupboard.
If cooker cannot be located against rear wall, move
anti-tilt plate forward to suit.
2. Securely x the anti-tilt plate to the oor with appropriate
fasteners.
3. Slide the cooker back into the anti-tilt plate so that rear
cover rests against the rear wall.
Then check the height and level of the cooker. If required,
pull the cooker back out and adjust the levelling feet as
required.
4. Fasten the stability bolt bracket to the front frame with the
2 screws supplied.
5. Reposition the cooker back into the anti-tilt plate and then
mark the position of the stability bolt hole.
6. Pull the cooker back out and drill the bolt location hole.
Use a 6.5mm masonry or wood drill. When drilling into
concrete ensure a minimum hole depth of 30mm.
7. Reposition the cooker back into the anti-tilt plate, aligning
the stability bolt bracket with the 6.5mm drilled hole. Then
slide the bolt through the bracket and into the hole.
8. Connect gas and electricity supply (refer to pages
following).
9. Fit the kick panel bracket and kick panel onto the cooker.
48mm to side
of bracket
Anti-Tilt Bracket
Rear Adjustable Foot
Cooker Width
600mm
Adjustable Feet
Stability Bolt
Stability Bolt Bracket
Kick-panel
Kick-panel Bracket
6.5mm Drilled
Location Hole
Loading ...
Loading ...
Loading ...