Loading ...
Loading ...
Loading ...
5. Locate bevel indicator and 10-24x1/4 pan
cross hd. screw in loose parts bag.
6. install bevel indicator and screw as shown
using a phillips screwdriver.
Th,
installed, assembly continues on p. 10, "Tension- _..
ing the Blade."
t
©
GUIDEBAR
REPLACaNG THE BLADE KNOB
.
Loosen the guide bar lock knob and position
the upper guide assembly approximately one
inch above the table and tighten lock knob.
BLADE UPPERGUIDE
2. Loosen the two blade guard mounting screws
and remove the blade guard. __'_-..
.
Loosen the guide bar lock knob and position
the upper guide assembly approximately two
inches above the table as shown and tighten
the lock knob.
.
Remove table insert, truss head screw, wash-
er and wing nut from the table (See Assem-
bly, p. 13 - "Adjusting the Table"). Replace
these parts after the blade is installed, ten-
sioned and tracked.
_,J -- !ll
ASSEMBLY _
5. Loosen the two screws in the front of the _'1
upper blade guide assembly that secure the _
blade guides and separate them about 1/8"
6. Loosen the two screws in the side of the
upper guide assembly and slide guides and _U _
thrust bearing all of the way back. 0
7. Tighten all screws.
8. Loosen the three (3)cover knobs by turning _o c0v
counterclockwise and remove cover.
NOTE: Replace the bandsaw cover after blade is _-_
properly installed, tensioned and tracked.
9
Loading ...
Loading ...
Loading ...