Loading ...
Loading ...
Loading ...
assembly
9. Loosen the two screws that secure the lower
blade guides and separate them about 1/8".
10. Loosen the screw holding the lower blade
guide support and slide support all the way ______...
toward the rear of the saw, and retighten all X
screws.
TENSION WHEEL -,. BLAOE
WARNING: TO AVOID BEING SCRAPED
SHOULD BLADE SUDDENLY UNCOIL, WEAR
SAFETY GOGGLES AND CAREFULLY UNCOIL
THE BLADE HOLDING IT AT ARMS LENGTH.
11. Place the blade over the wheels with the
teeth pointing downward toward the table as
shown. Make sure the blade is in the center
of the rubber tires.
TENSIONING THE BLADE
TENSION LOCK
SLOT iN TABLE
WHEEL
IDLER WHEEL
NOTE: Your bandsaw can use only 1/4 inch wide
blades, 56-7t8 inches long. A blade is included
with this saw.
1.
.
.
Loosen the tension lock knob (1/4 of a turn
counter-clockwise). Turn the tension adjust-
ing knob clockwise until blade has proper
tension. To check blade tension, push thumb
against side of blade between lower wheels.
Blade should move only slightly with moder-
ate pressure. Be careful not to overtension
blade. Retighten tension lock knob.
If too much blade tension has been applied,
blades may tend to break more easily and
blade life will be shorter.
If too little blade tension has been applied,
blade may not track easily, may slip on
wheels, or wilt move too easily when check-
ing tension.
Turn the upper wheel by hand clockwise a
few turns and notice if the blade remains in
the approximate center of the tires.
NOTE: Tension lock knob must be tightened
before moving blade.
If the blade moves away from the center of
the tires while you are turning the wheels,
the Made is not TRACKING properly.
10
TENSION
ADJUSTING
KNOB
Loading ...
Loading ...
Loading ...