Loading ...
Loading ...
Loading ...
18
19
TROUBLESHOOTING GUIDECLEANING & MAINTENANCE
cleaning & maintenance
nuwavenow.com
ENGLISHTroubleshooting Guide
Plunger Lid Seal Ring Assembly
It may be necessary to remove the Plunger Lid Seal Ring for
occasional cleaning or to replace the part if it becomes worn or
damaged. To assemble:
1. Line the inside of the Plunger Lid Seal Ring into the rim.
2. Press the Seal Ring into the rim to ensure it is properly sealed.
3. Make sure the lower part of the Plunger Lid Seal Ring lines up
with the bottom side of the rim.
Silicone Pad Removal
It may be necessary to remove the Silicone Pad for occasional
cleaning or to replace the part if it becomes worn or damaged.
To remove:
1. Lift up one corner of the Silicone Pad.
2. The Silicone Pad is tightly secured so make sure to carefully
pull out the Pad until it is removed.
Silicone Pad Cleaning
The Silicone Pad is dishwasher-safe, top rack only. It can only also
be handwashed with warm soapy water.
Seal Ring
Plunger Lid Rim
Lift Corners
Quiet Cover Silicone Lining
The lining on the bottom of the Quiet Cover is removable and can
be washed with warm, soapy water. To attach it back onto the Quiet
Cover, align the rectangular hinges of the Silicone Lining to the
rectangular holes on the Quiet Cover.
The Innity Blender
™
Pro Plus is not turning on or working.
1. The plug may not be in the outlet. Plug the Infinity Blender
™
Pro Plus into an appropriate power source.
2. The Red Power Switch on the right side of Base may not be
on. Check to see if the Power Switch is on.
Blender is not running at a high enough speed for the recipe.
1. The dial is not on the correct setting. Turn the dial to the
proper setting based on the recipe.
2. The Jar is overloaded. Reduce the amount of ingredients
being used.
Blender is becoming clogged and not operating efficiently.
1. Certain ingredients can cause clogging. Remove the Plunger
Cap from Lid and insert the Plunger through the hole. Press the
ingredients down and around until the mixture loosens around
the bottom of Jar.
2. The amount of ingredients is greater than specified in the recipe.
Do not fill the Jar above ¾ capacity (42oz.).
3. Large pieces of ice are not mixing properly. Use smaller pieces
of ice. Use the Plunger to break up the pieces.
Blended mixture has lumps or texture is not even.
An air pocket has formed (cavitation) and the mixture is too cold
or has solidified in areas, and the Blades are spinning in the
cavity. Increase the temperature by reducing the amount of ice in
the recipe. Use the Plunger to eliminate lumps.
Noises or motions unusual for normal operation of the
blender are detected.
1. The Blade assembly may be loose, missing a part, or
damaged. Turn the blender off and unplug it immediately. DO
NOT disassemble the blade assembly. Call Customer Service:
1-888-502-7807 or email support@nuwavenow.com.
2. Foreign objects from ingredients may have been put into the
Jar and are making unusual sounds. Prior to adding your
ingredients to the Jar, clean any raw ingredients and remove
all debris or any other objects.
The Infinity Blender
™
Pro Plus was engineered with an automatic
shut-off feature to prevent overheating during use. If the blender
shuts off to cool itself down, an odor may be detected. Unplug
the Infinity Blender
™
Pro Plus and wait for it to completely cool
down. To prevent overheating, do not process foods above the
recommended speeds.
Loading ...
Loading ...
Loading ...