Loading ...
Loading ...
Loading ...
_ILCAUTION: Before performing any
service or adjustments:
1. Release control bar and stop engine.
2. Make sure the blade and all moving
parts have completely stopped.
3. Disconnect spark plug wire from spark
plug and place where it cannot come
in contact with plug.
LAWN MOWER
TO ADJUST CUTTING HEIGHT
See "TO ADJUST CUTTING HEIGHT" in
the Operation section of this manual.
REAR DEFLECTOR
The rear deflector, attached between the
rear wheels of your mower, is provided to
minimize the possibilitythat objects will
be thrown out of the rear ofthe mower
intothe operator'smowing position. If the
deflector becomes damaged, it should be
replaced.
TO ADJUST HANDLE
The handle can be mounted in a high or
low position. The mounting boles in the
bottomof lower handle are off center for
raising or lowering the handle.
1. Remove upper handle and all parts
attached to lower handle.
2. Remove hairpin cotters from lower
handle bracket mounting pin.
3. Squeeze lower handle in to remove it
from mounting pins.
4. Turn lower handle over to raise or
lower handle.
5. Squeeze lower handle in and position
holes onto mounting pins on handle
bracket.
6. Reassemble upper handle and all
parts removed from lower handle.
Lower
handle
Rotate
TO ASSEMBLE GRASS CATCHER
1. Put grass catcher frame into grass bag
with rigidpart ofbag on the bottom.
Make sure the frame handle isoutside
of the bag top.
2. Slip vinyl bindingsover frame.
NOTE: If vinyl bindingsare too stiff, hold
them in warm water for a few minutes. If
bag gets wet, let it dry before using.
ACAUTION: Do not run your lawn
mower without clippingdeflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
".,_ Frame
ENGINE
ENGINE SPEED
Yourengine speed has been factory set.
Do notattempt to increase engine speed
or it may result in personal injury.If you
believe that the engine is runningtoo fast
or too slow,take your lawn mower to a
Sears or other qualified service center for
repair and adjustment.
CARBURETOR
Your carburetor has a non-adjustable
fixed mainjet for mixture control. If your
engine does not operate properlydue to
suspected carburetor problems, take your
lawn mower to a Sears or other qualified
service center for repair and/or adjust-
ment.
IMPORTANT: Never tamper withthe
engine governor, which is factory set for
proper engine speed. Overspeeding the
engine above the factory highspeed
setting can be dangerous. If you think the
engine-governed high speed needs
adjusting, contacta Sears or other
qualified service center, which has proper
equipment and experience to make any
necessary adjustments.
14
Loading ...
Loading ...
Loading ...