Loading ...
Loading ...
Loading ...
Air Conditioner Features
(continued)
REMOTE SENSING FEATURE
(on some models) "
LIGHT pulsing On & Off intermittently,
DO THIS:
PRESS REMOTE
SENSING
BUTTON ON
NOTE: Unit display shows "set" temperature NOTE: Remote display
is actual temperature at
remote control only
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing button. Next, use the _ _'
buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit itself). The LIGHT on
the unit control will pulse to indicate it received the signal. The LIGHT on the remote control will pulse each time it sends a signal. It will con-
tinue to send this signal until the feature is deactivated bypressing the remote sensing button. Ifthe unit does not receive the remote sensing
signal during any 3 minute interval, the unit will beep to indicate the remote sensing mode has ended. The display on the remote control indicates
the temperature at the remote ONLY. The unit display indicates the set temperature.
HEATING FEATURE (on some models)
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT
Note: This feature can be used with any combination of FAN Speeds, Timer, or Sleep Modes. When in the "Heat" Mode, the fan will run
continuously while heat is needed. The temperature will automatically be maintained anywhere between 55°F (18°O) and 80°F (270).
When the room set temperature is satisfied, the fan will cycle off and on to circulate and sample the room air.
FAULT CODES
If the display reads "AS", a sensor has failed.
Contact your Authorized Frigidaire Service Center.
If the display reads "HS", a sensor has failed.
Contact your Authorized Frigidaire Service Center.
Loading ...
Loading ...
Loading ...