Loading ...
Loading ...
Loading ...
important Safety
instructions
_N TE The power supply cord with
this air conditioner contains a current
detection device dasigned to reduce the risk
of fire.
Please refer to the section 'Operation of
Current Device' for details.
In the event that the power supply cord is
damaged, it cannot be repaired-it must be
replaced with a cord from the Product
Manufacturer.
Avoid fire hazard or electric
shook. Do not use an extension cord or an
adaptor plug. Do not remove any prong from
the power cord.
Power supply cord
with 3-prong grounding
plug and current
detection device
Read eli ir_tructions before using this air conditioner.
For "four Safety
Do not store or ase gasoline or other flammable vapors and liquids in the vicinity of this or-ar_/
other appliance. Read product labels for flammability and other warnings.
Prevent Accidents
To reduce the risk offire, electrical shook, or injury to persons when using your air conditioner,
follow basic precautions> including the following:
- Be sure the electrical service is adequate for the model you have chosen. This information
can be found on the serial plate, which is located on the side of the cabinet and behind the
grille.
- tf the air conditioner is to be installed in a window>you will probably want to clean both
sides of the glass first. If the window is a triple-track type with a screen panel included,
remove the screen completely before installation.
• Be sure the air conditioner has been securely and correctly installed according to the
separate iastallation instructions provided with this manual. Save this manual and the
installation instructions for possible future use in removing or reinstalling this unit.
• When handling the air conditioner> be careful to avoid cuts from sharp metal fins on front
and rear coils.
Electrical information
The complete electrical rating of your new room air conditioner is stated on the serial plate.
Refer to the rating when checking the electrical requirements.
• Be sure the air conditioner is properly grounded. To minimize shock and fire hazards,
proper grounding is important. The power cord is equipped with a three-prong grounding
plug for protection against shook hazards.
- Your air conditioner must be used in a properly grounded wall receptacle. If the wall
receptacle you intend to use is not adequately grounded or protected by a time delay fuse
or circuit breaker, have a qualified electrician install the proper receptacle.
, Do not run air conditioner with outside protective cover in place. This could result in
mechanical damage within the air conditioner.
= De not L_e an e_ension cord or an adapter plug.
READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER.
Operation of Current
Device
Plug in &
preas RESET
NOTE: Some plugs have
buttons on the top.
The power supplycerd contains a current de,,a'cethat senses damage to the power cord To test your
power supply cord do the following:
1 Plug in the Air Conditioner
2 The power supplycerd w[ll have T;NO buttons on the plug head Press the TEST button You wilt
notice a click as the RESET button pops out
3 Pres<_the RESET button Again you will notice a click as the button engages
4 The power supply cord [s now suppl'_ng electricity to the unit (On some products th[s [s also indi-
cated by a light on the plug head)
NOTES:
- Do net use this de'_ce te turn the unit en or-off
o Alwa,_s make sure the RESET button is pushed in Ier correct operation
- The power supply cord must be replaced [f [tfa[Is to reset when either the TEST button [s pushed, or
[t cannot be reset Anew one can be obtained from the product manufacturer
, If power supply cord is damaged, it CANNOT be repa[red It MUST be replaced by one obtained from
the product manutacturer
Loading ...
Loading ...
Loading ...