Loading ...
Loading ...
8_
HOW TO ASSEMBLE YOUR
NEW HOOVER CLEANER
ASSEMBLE HANDLE PIECES
Remove cardboard from end of handle pieces.
Slide the two handle pieces together. Check to
see that cord clips are on the same side of the
handle. Insert bolt through small holes and
secure with nut. Tighten nut with screwdriver.
If the nut and bolt are not
assembled as shown in the
illustration, the holes in the
handle pieces are not lined
up correctly.
ATTACH HANDLE TO CLEANER
Unscrew nut and remove bolt and
plate from handle socket. Place
handle so that the holes in the
bottom of the handle are directly
in line with the electrical prongs
and make sure the handle is posi-
tioned so that the switch is to
rear of cleaner.
Push down until handle is secure-
ly in place. Insert bolt through
small holes of handle pieces and
secure with nut. Tighten nut
with screwdriver.
If bolt appears too short, the
plate is on backwards or upside
down. Make sure that the con-
tour of the plate fits around the
handle as in illustration.
OPERATE THIS CLEANER ONLY AT VOLTAGE SPECIFIED
ON DATA PLATE ON BOTTOM OF CLEANER.
Loading ...
Loading ...
Loading ...