Loading ...
Loading ...
Loading ...
1615
5.2.4 HOW TO CLEAN THE SEAL RING
5.2.3 TROUBLESHOOTING DURING THE BREWING
(1) When the machine starts to work , there will be some noise comes
out from the machine as it is pumping the water with a high pressure.
(2) When you finish making espresso and turn the coffee/steam knob
selector ❹ back to “ 〇 ”position, the pressure relief hole will make a
loud noise. It is because the machine relieving the pressure, which is
normal and not a problem.
(3) To achieve a full flavor, each one cup of espresso should be not
more than 30ml, while two cups of espresso is 60mL.
(4) While during operation , if there is suddenly a loud noise from the
machine, which may due to not enough water in the water tank ⓰ .
In this case, please remove the portafilter ❽ and clean the coffee
powder and don't use the inside coffee powder again. Then continue
to brew coffee from step 1 of 5.2.1 THE STEPS OF MAKING ESPRESSO.
(5) During brewing, when you find the coffee leaks out from outer side
of portafilter ❽ or doesn’t flow smoothly, it have several reasons
as below and you should stop the operation by turn the coffee/steam
knob selector ❹ back to “ 〇 ”position. Remove the portafilter ❽ and
clean the coffee powder and don't use the inside coffee powder again.
Note: (Please mind the hot water and operate carefully)
NOTE: As the seal ring of the water outlet is designed to pre-
vent from leaking, once there is too much coffee powder left,
the seal ring will be blocked. If the seal ring is blocked, it will
lead to the espresso leakage or splash when brewing espresso.
For this reason and for healthier, we suggest you to clean it
every time after use with hot water from the brewing function.
If it is not cleaned in time, it will produce a bad smell.
Function Operation Picture Light
Restore the double
cup default setti-
ngs
After corresponding cup icon flash, the icons on the LED display screen ❶
become fixed, the machine will back to ready mode. The machine is restored
to the default value.
Double cup icon flash
3 times after 2 seco-
nds
1.There is some coffee powder on
the edge of portafilter ❽.
Clean coffee powder on the edge
of the portafilter ❽.
2. The portafilter ❽ is not installed
properly.
Re-install the portafilter ❽ correctly.
3. The coffee powder is too fine.
Do not use coffee powder that is too
fine.
4. The coffee powder on the porta-
filter ❽ is pressed too tightly.
Press the coffee powder lightly to
the max line.
5. The two outlet holes of the port-
afilter ❽ is blocked.
Remove the filter and clean the two
outlet holes under the portafilter ❽.
6. The holes of the filter is blocked.
Soak the filter in clean water for about
half an hour, then clean it with a brush.
1.Turn the coffee/steam
knob selector ❹ to the
espresso function icon
2.Long press double
cup button from the
ready mode
Possible Cause Solution
x2
Loading ...
Loading ...
Loading ...