Loading ...
Loading ...
Loading ...
30
Chime
A signal will sound at the end of each cycle
(and periodically during extended refresh) if
option is activated.
To mute or unmute the chime, press and hold
the select button for 3 sec.
MIN
CLOSE DOOR
CALL
SERV ICE
ANY STAIN BLOOD CHO CO L ATE
O O RD
options
select
de-select
hold ‘select’ 3 s to mute/unmute
Other features
LED display
The estimated total cycle time will be
displayed when the cycle is selected. The
time may increase if water pressure is low,
oversudsing occurs or the load becomes
unbalanced. The approximate time
remaining will be displayed during the cycle.
The eco, control lock, close door, mute
(some models), and delay time will also
appear on this LED display.
Icons may vary according to model.
Eco indicator
The eco symbol will light up on the LED display
to indicate that the selected combination of
temperature, spin speed and options are eco
friendly.
Oversuds protection
A situation where oversudsing has been
detected by the washer will result in the
washer requiring additional rinses until the
suds have been cleared. Each extra rinse
the washer performs to clear the suds will
add approximately 5 minutes to the cycle
duration. The LED will display “SU” followed
by “dS” and then the remaining cycle time (0
min) for 60 seconds and then repeat. Press
(60 sec loop)
Drum light (on select models)
The drum light will come on whenever
the door is opened to illuminate the drum
during loading and unloading. Closing the
door turns off the light. The drum light will
automatically turn off if the door is left open
more than 3 minutes.
Reversible door (on select models)
Your washer may be equipped with a
reversible door. The door can be hinged on
the right or left side.
Trapped item detection
If an item is detected to be trapped between
the door and the door gasket, the washer
will pause the cycle and play an alert chime.
The LED will display a loop of “CLEAr door”
as shown below until the cancel button is
pressed. Press the cancel button to unlock
the door and remove the trapped item, then
close the door and restart the cycle.
cancel to turn off the alert message. The
washer will continue to perform rinse cycles
until suds are removed.
Reversed Hose Detection
If condition is detected where the inlet
hoses have been installed incorrectly (hot
supply to cold inlet and cold supply to hot
inlet), the washer will alert you. The LED will
display “HO” followed by “SE” and then the
remaining cycle time (0 min) for 60 seconds
and then repeat. Acknowledge the reversed
hose condition by pressing the cancel
button. Shut off each water supply valve and
attach each supply hose to the correct inlet
connection on the washer.
(60 sec loop)
(60 sec loop)
(60 sec loop)
CONTROLS AND SETTINGS
Loading ...
Loading ...
Loading ...