Loading ...
Loading ...
Loading ...
28
Cycle options
Max (on select models), high, medium and
low (on some models) spin speeds are
available for each cycle. The spin speed
and/or duration of final spin vary from model
to model and cycle to cycle.
Increasing the spin speed will extract more
water, decrease drying time and conserve
energy. Decreasing the spin speed will
reduce wrinkling.
Select low spin speed (on some models) to
gently spin items that should be line dried.
Use no spin to omit the final spin at the
end of the cycle. The load will be very wet.
Remove items from the wash drum to drip
dry or select a spin only cycle to remove
excess water at a more convenient time.
Spin speed
The default options for each cycle will
automatically be chosen when a cycle is
selected. To protect fabrics, not all options
are available for all cycles. If an option is
not available for a cycle, the indicator will
not light.
options
select
de-select
Selecting options
Press the option button to scroll though
the options until the indicator light for the
desired option flashes, then press select.
The indicator light will illuminate when
the option has been selected. Follow the
same steps to deselect an option. The
indicator light will turn off when the option is
deselected.
All settings or options selected for the cycle,
except sanitize (on select models), perfect
steam
TM
(on select models), and stain
treatment options, will be remembered and
recalled each time that cycle is selected
in the future. To return to factory settings,
press and hold soil and options buttons at
the same time and hold for 3 seconds until
the confirmation signal sounds. To prevent
unintentional and accidental exposure
of delicate material to excess heat or
unexpected steam, the sanitize, perfect
steam
TM
and all stain treatment options will
need to be reselected each time.
Stain treatment options
(on select models)
Your washer is equipped with powerful stain
treatment tools. Depending on your model,
use one of the options below to deal with
tough stains on your garments. See step 5
in the
Operating Your Washer
section in this
manual for details on adding stain additives
to the dispenser.
StainTreat (400 series washer)
Select this option to add a short initial wash
period to available cycles using the stain
treatment additives in the stain soak/treat
compartment. After the stain wash phase,
the load will automatically advance to the
main wash cycle.
StainTreatII (500 series washer)
Select this option when available and rotate
the cycle selector to rotate through the
stain types below. Stain treatment and main
detergent will recirculate in the agitating load
for approximately 20 minutes and then the
washer will advance to the main wash cycle.
• Any Stain
Recirculating wash solution will be
heated by boost heater.
• Blood
Recirculating wash solution will NOT
be heated by boost heater to prevent
setting blood stains.
NOTE
If changes to the settings or options are
attempted after the cycle starts, you will
hear several beeps when the buttons are
pressed. To change settings or options,
press start/pause, make the new selections
and press start/pause again.
CONTROLS AND SETTINGS
NOTE
The washer will ALWAYS use a small
amount of HOT water to dissolve the pack
when the PODS
®
option has been selected.
Adjust the wash time based on the soil level
of each load. Solid soil (on select models),
heavy, normal, light and extra light (on
some models) soil levels are available.
Soil level
Loading ...
Loading ...
Loading ...