Loading ...
Loading ...
Loading ...
NOi"£_; £')Jc _et'_o_'edevce mus_ k_e
p_o_7 4s,mme_:Fse;_4s,sf#/e,y
h,!O_]]!_;Remo_e co '9"oFs w _'_e cos_, dec F
NO _#,]f: WG_e_puogms_ mm8 _emog,!:;c@'s_,!'e,;, must
1. Program one button remote.
• Lower lens cover.
. Locate learn code button and learn indicator on
power head Fig. 9-1.
• Press and release learn code button.
- Red learn indicator blinks 2 times per second.
• Press remote control button once within
30 seconds.
- Red learn indicator stays lit.
• Press remote control button again.
- Red indicator goes out and memory
is stored.
des per seeor:_d, p_ogx_;mmm£ ha s_o_p_ed,
2. Program multi-button remote.
= Repeat step 1 above "Program one-button
remote" for each button and operator.
sf_sFngFe does
3. Operating remote.
• Press button once:
- If door is at up or down limit, door will move
away from that limit.
- If door is stopped between limits, it will move
toward the limit where it was last stopped.
- tf door is moving, it will stop.
e/ose e}_;_;/#:,_,
Learn Indicator
To erase all receiver memory, such as
following loss of remote, home sale or
tenant turn=over
• Press and hold learn code button for
10 seconds or until learn code
indicator goes out--memory is erased.
• Program remotes as before.
FCC and IC CERTIFIED
This device complies with FCC Part 15 and RSS
210 of Industry Canada. This equipment has been
tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide
reasonable protection against harmful interference
in a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications. However,
there is no guarantee that interference will not
occur in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Re-orient or relocate the receiver antenna.
• Increase the separation between the operator
and receiver.
• Connect the operator into an outlet on a circuit
different from that to which the appliance
is connected.
• Consult the dealer.
Loading ...
Loading ...
Loading ...