Loading ...
Loading ...
Loading ...
Operating
Instructions
e
Page 8
f
¥
X
table
Note:
1. Please make sure the unit is placed on a flat, horizontal
table to prevent toppling and sliding.The tilt angle needs
to be less than 1 degree.
2. Please make sure the tube is properly connected to the
drain before entering the bucketless mode.
4. On the Bucketless mode, don’t touch the switch or the
unit will exit Bucketless mode.
switch
5. Don’t move the unit when it is working. Turn off the
power and remove the plug before moving the unit.
3.The overall height of the tube should be lower than the
drain to avoid water backflow and ensure smooth discharge.
¥
X
X
10cm or more
NOTE: At the Bucketless mode, the hight of table is
more than 10cm.
Place the end of the hose into the drain area or the
container to catch the water.
Bucketless mode (on some models)
The dehumidifier can be used without bucket when
the unit is under Bucketless mode.
The unit will not reminds the water to be full after
entering the bucketless mode, therefore, it is suggested
that:
1. Check whether the tube is properly connected;
2. Link the other end of the tube to a place with
unlimited capacity, such as a sink or a basin;
3. Do not place the other end of the tube in a
container with limited capacity, otherwise the
water may overflow to the floor.
Exit the bucketless mode：
1. Press FILL LEVEL and up to exit
2. Turn off the power
NOTE: It may cause an unexpected exit from the
bucketless mode when the tank float touches the
micro switch (at the bottom of the unit). So please
check whether the bottom of the unit is clear under
the bucketless mode.
tilt angle
Loading ...
Loading ...
Loading ...