Loading ...
Loading ...
Loading ...
OPERATING INSTRUCTION PLATE
CONVECTOR RCE-329A
FOR YOUR SAFETY READ BEFORE OPERATING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing
property damage, personal injury or loss of life.
A. This appliance does not have a pilot. It is equipped If you cannot reach your gas supplier, call the fire
with an ignition device which automatically lights the department.
burner. Do not try to liqht the burner by hand.
B,
BEFORE OPERATING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and wil! settle on
the floor.
WHAT TO DO IF YOU SMELL GAS.
Do not try to light any appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Immediately ca[I your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
C,
D.
Use only your finger to push with. Never use tools. If
the button will not reactivate by touch, don't try to repair
it, call a qualified service technician. Force or
attempted repair may result in a fire or explosion.
Do not use this appliance if any part has been under
water, immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas contro_ which has been
under water.
OPERATING INSTRUCTIONS
• STOP! Read the safety information above on this
label. This appliance is equipped with an ignition
device which automatically lights the burner. Do not try
to light the burner by hand.
1. Turn off all electdc power to the appliance via the
ON/OFF button on the control panel. Locate manual
gas valve to be found on back side of heater.
2. Turn Manual valve clockwise _ to the full OFF
position.
3. Wait five (5) minutes to clear out any gas. Then smell
for gas, including near the floor. If you then smell gas,
STOP! Follow "B" in the safety information above on
MANUAL VALVE
CLOSED OPEN
this label If you don1 smell gas, go to next step.
4. Turn Manual gas valve to the full ON position.
5. Turn on all electdc power to the appliance.
6. Press ON/OFF button to =ON".
7. Set the thermostat to desired setting.
8. Burner is lit when operation lamp glows red.
9. If operation lamp is flashing red, burner has not been
[it.
10. If tha appliance will not oporete, follow the instructions
"To turn off gas to appliance" and call your service
technician or gas supplier.
RoomTemperature
Da_ay
FitterW=mingLanp
@@-®
Temper=t_e Temperature Furicbon Ign_on
Down Up Lock Button
TO TURN OFF GAS TO APPLIANCE
1. Turn off electric power to the appliance using the
ON/OFF switch located on the control panel.
2. Turn manual valve clockwise _ to the full OFF
position.
NOTE: The fan will continue to operate until the appliance is
cool, do not turn the appliance off by unplugging it from the
wall. Keep burner and control compartment clean. See
installation and operating instructions accompanying heater.
WARNING: Improper installation, adjustment, alteration,
service or maintenance can cause personal injury or loss of
life. Refer to the owner's information manual provided with
this appliance. Installatian and service must be performed
by a qualified installer, service agency or the gas supplier.
-9-
Loading ...
Loading ...
Loading ...