Loading ...
Loading ...
Loading ...
E_
Loosentheboltsusingtheclosed
endofthe1/2"wrenchprovided.
Loosenthemuntiltheycanbere-
movedfreely.
Therecessedbottomboltsmaybe
moreeasilyremovedusinga1/2"
(13mm)socketwrench.
Completelyremoveall4transport
boltassemblies(bolt,spring,washer
andbushings)byreachingthrough
theopenwashingmachinedoorand
pullingthedrumslightlyforwardto
loosen,thenpulloutfromtheback.
Ifthebushingsdonotcomeout
whenremovingthebolts,placethe
boltsbackintothebushingsand
carefullytryagain.Itisimportantto
dothiswiththebolts,otherwisethe
bushingswillnotcomeoutproperly.
Tostoretheboltsforfutureuse,do
notremovetheboltsfromthe
plasticbushings.
E_
completely.
Insertthecoversuntiltheysnapin
Storingthe transport bolts
Alwayskeepthetransportboltsforfu-
turetransportationoftheappliance
(suchaswhenmovingout).
Storethetransportboltswiththe
washerandbushingattached.
Water connection
Water supply
The washing machine must only be
operated with cold and hot (max.
140 °F/ 60 °C)tap water. Do not
connect the appliance to the mixer
tap of an unpressurized hot-water
boiler.
If in doubt, have the water connection
installed by an authorized technician.
The water supply hoses must not be:
- Bent or flattened.
- Modified or cut (integrity can
no longer be guaranteed).
Observe the water pressure in the
supply network:
- The water pressure should be
between 14.5 and 145 p.s.i.
(1 and 10 bars) when the tap
is turned on, at least 2.2 U. S.
gallons (8 liters) of water should be
discharged per minute.
- A pressure regulator valve must be
installed if the maximum water
pressure is exceeded.
To prevent water damage, the hot
and cold water valves should be
accessible when the washing
machine is in place and should
always be turned off when the
washing machine is not in use.
If installing the washing machine in a
new building or a building in which
the plumbing system was recently
installed or upgraded, flush the lines
before installing the washing
machine to remove any sand, dirt or
residue.
Supply Line Connection
C Cold water connection and
H Hot water connection
(max. 140 °F / 60 °C)
E3
Plastic threads must only be
tightened by hand when
connecting the water supply hoses
to the back of the unit. Do not
remove the strainers from the
water supply hoses.
After connecting, turn on the water
completely, and check that
connection points are watertight.
The connection points are under full
water pressure. Check seal with tap
fully open.
Loading ...
Loading ...
Loading ...