Loading ...
Loading ...
Loading ...
Connectionslocatedontherearofthe Dimensions c_ units are not designed to be
appliance: stacked.
- Power cord with plug.
H = hot water connection
C = cold water connection
Useful tools
The following tools are helpful:
1. Flat head screwdriver.
2. Socket wrench (1/2" / 13mm).
3. Closed wrench (1/2" / 13 mm).
4. Bubble Level.
a = 27.0 inches (686 mm)
b = 30.7 inches (780 mm)
c = 37.0 inches (940 mm)
d = 16.0 inches (407 ram)
Door opening angle 180°
Approx. weight = 220 Ibs (1O0 kg)
Installation area
Never ground the washer to plastic
plumbing lines, gas lines or hot
water pipes.
This appliance must be installed on
a solid floor and well leveled due to
the higher spin speeds available. If
installing the machine on a wood
floor over a basement or on a
second floor, the floor may need to
be reinforced. Sound, vibration, and
risk of "walking" will be affected
depending on the structure and
stability of the floor surface where it
is installed.
_1 Units are not designed for under
counter installation
Pedestal Mounting
If mounting the washer on the Bosch
pedestal (accessory no. WTZ1295, for
colored variant, accessory no.
WTZ1295S) ) follow the instructions
supplied with the pedestal.
D Install pedestal prior to
removing transport bolts.
Closet
If installing the washer in a closet,
observe the minimum distances
according to the following table:
Minimum Installation Clearances
Closet
Sides 1/4" (6 mm)
Top 12" (305 mm)
Rear 25" (64mm)
Front 1/4" (6 mm)
Ventilation:
Top: 48 sq. in (310 sq. cm),
Bottom: 24 sq. in (155 sq. cm)
Checklist for Page
Installation
completelyremove4 shippingbolts 7
movethe washerintoplace
connectthe water supplylineand 8
drainpipe
connectthe electricalpower 10
slidethe washerinto its final location 11
levelthe washeras 10was possible 11
beforefirst use, run a cleaningcycle 15
If the washing machine is to be installed
on a weak wood floor consider the
following:
_1 Soft floor surfaces, such as
carpets or surfaces with foam
backing, are not suitable. If
possible, place the washing
machine in a corner of the room.
_1 Screw a water resistant wooden
board (at least 3/4" thick) to the
floor.
E3
Secure the feet of the washing
machine with holding brackets.
Order the holding brackets (set)
from Bosch Customer Service
(WMZ 2200).
Removing the transport bolts
E3
E3
To avoid possible injury and damage
to the appliance and adjacent
surfaces, all 4 transport bolts must
be removed before using the
appliance for the first time and must
be retained for any future transport
(e.g. when moving).
Loosen all four bolts before
removing any of the bolts all the
way from the unit.
Remove the bottom two bolts prior
to removing the top two bolts.
Loading ...
Loading ...
Loading ...