Loading ...
Loading ...
Loading ...
13
Installation
5. Stick the upper duct divider into the
assembled mounting frame.
NOTE: Make sure the upper duct
divider is compressing the top foam
on the base of the unit, and compress
to doubled sided tape on the lower
duct divider to ensure a positive
retention. (Fig. 6)
Upper Duct
Divider
Fig. 6
6. Peel to remove the release paper
from the EVA foam, overlap the sticky
side over all gaps and compress to
seal and insulate the entire section.
(Fig. 7)
PE Foam
Fig. 7
7. Use self adhesive foil tape to seal all
remaining gaps around the duct divder,
EVA foam and roof opening, completely
sealing duct edges as required.
8. Remove the cable compartment cover
using a Phillips screw driver. (Fig. 8)
Fig. 8
DANGER
Electrical Shock Hazard
● Disconnect power before servicing.
Failure to obey this warning could
result in death or serious injury.
● Provide grounding in compliance
with all applicable electrical codes.
Failure to obey this warning could
result in death or serious injury.
9. Loosen the strain relief on top of
the control box and pass the 115VAC
power cord through the strain relief.
(Fig. 9)
NOTE: Always follow the color code
while connecting the cables.
Black - Hot
White - Neutral
Green/yellow - Ground
Fig. 9
10. Tighten the cable clip until the cable
is properly restrained.
NOTE: Do not over tighten.
11. Fit all cables into the cable
compartment and tuck any excess
Loading ...
Loading ...
Loading ...