Loading ...
Loading ...
Loading ...
DRAPER TOOLS LTD, HURSLEY ROAD, CHANDLER'S FORD, EASTLEIGH, HANTS. SO53 1YF. U.K.
www.drapertools.com e-mail: [email protected]
SRDH0716
4
Attach the connection bar ((I) to the yoke
(G) and the front axle sub-assembly (F)
using M6 x 17 shoulder bolts (G x 2), M6
washers (H x 2) and M6 lock nuts (I x 2).
Tighten enough to allow the connection
bar and axles to pivot. Fit the M10 washer
(E) over the pivot pin and secure with the
cotter pin (F) by fitting it through the hole
in the pivot pin and bending out the ends.
STEP 3
NOTE. The cross brace of the bed
with the two holes closer together is
the front end of the cart.
Attach the assembled front axle
sub-assembly (F) to the side rails of the
bed (A) using M8 x 20 carriage bolts
(J x 2), M8 washers (C x 2) and M8 lock
nuts (D x 2). Attach one end of the front
struts (H) to the assembled front axle
sub-assembly using M8 x 20 hex bolt
(O x 2), M8 washers (C x 2) and M8 lock
nuts (D x 2). Fit one M8 x 25 carriage
bolt (P x 1), one M8 washer (C x 1) and
one M8 lock nut (D x 1) to the other end
of each front strut (H).
The bolt head must be on the underside
of the strut. Push the head of the bolt
though the hole in the cross brace of the
bed and slide side ways so the square
under the head of the bolt fits into the
slot of the cross brace. Keep upward
pressure on the strut and tighten the
nut. Repeat for the other strut.
Once the struts have been secured to
the cross brace tighten the four
remaining nuts and bolts.
STEP 4
Loading ...
Loading ...
Loading ...