Loading ...
Loading ...
NOTE: During each step of assembly,
assemble all hardware and hand
tighten. Once all the hardware is
installed for that particular step,
tighten all hardware.
Turn the cart bed upside down. Use the
cardboard from the carton to keep from
scratching or damaging the finish.
NOTE: The cross brace of the bed with
the two holes closer together is the
front end of the cart. The cross brace
with the two holes farthest apart is the
rear of the cart.
Attach the yoke (G) to the front axle
sub-assembly (F) using M8 x 210 carriage
bolt (B x 1), M8 washer (C x 1) and M8
lock nut (D x 1). Tighten enough to allow
the yoke to pivot freely.
SRDH0716
DRAPER TOOLS LTD, HURSLEY ROAD, CHANDLER'S FORD, EASTLEIGH, HANTS. SO53 1YF. U.K.
www.drapertools.com e-mail: [email protected]
STEP 1
PREPARATION FOR ASSEMBLY
STEP 2
As your garden cart requires assembly, first check off the included parts and fittings against the
listings on page 1 – ‘What’s in the box?’ section. Tools required for assembly include:
*Tools below are sold separately and shown for visual guidance only.
1 x 150mm
long nose pliers.
1 x 10mm spanner.
1 x 13mm spanner.
10mm, 13mm &
19mm So cket
and Ratchet.
3
Loading ...
Loading ...
Loading ...