Loading ...
Loading ...
Loading ...
SANTOS : User and maintenance manual
98101 EN 3.8 - 04 2022 8 / 23 www.santos.fr
too close to each other, which could cause damage to the grinding unit.
ADJUSTING THE MINIMUM GAP BETWEEN THE GRINDING-WHEELS
This should be done after replacing the grinding wheels.
Models: #01, #01PS, #01P, #04
1. Plug the appliance in and run it empty.
2. Unscrew hexagon socket screw (7) on the dial (4) using a 2-mm Allen wrench.
Check that the dial (4) is free to rotate without turning button (6).
3. Turn button (6) anticlockwise until the grinding wheels come into contact (a slight
sound of friction will be heard) then back one notch in the reverse direction.
ATTENTION
This is a delicate operation, and prolonged contact between the grinding wheels
should be avoided, since this could damage them.
4. Turn the appliance off by placing switch (13) on "0".
5. Without moving the button (6), place the dial (4) on the "FINE" position then tighten
the hexagon socket screw (7) fully home.
6. Run the machine empty to check that the grinding wheels rotate without touching
each other on the finest setting. If this is not the case, repeat the above procedure.
Model: #01BAR
1. Plug the appliance in and run it empty.
2. Unscrew the locking screw (21) of the graduated ring (20). Check that the ring (20)
turns freely without driving the adjusting button (6)
3. Turn button (6) counterclockwise until the grinding-discs come into contact (a slight
rubbing noise can be heard) then turn slightly in the opposite direction so that they
are no longer touching one another.
BE CAREFUL
This is a delicate operation and prolonged contact between the grinding-discs
should be avoided as this could damage them.
4. Stop the machine by pressing the On/Off button (13).
5. Without moving button (6), align the "0" of the graduated ring (20) with the red
index mark (22) (ring at end position), then tighten the locking screw (21) without
moving the graduated button or the adjusting button.
6. Run the machine empty in the finest grind position ("0"), to check that the grinding-
discs rotate without touching other. If this is not the case, repeat the above
procedure.
!
!
Loading ...
Loading ...
Loading ...