Loading ...
Loading ...
Loading ...
6
of the water. Once the set temperature is reached the light ring will glow steadily in the
colour corresponding to that temperature. The light in the temperature control button will
also go out.
• To switch off manually, press the temperature control button again (the light in the
temperature control button will go out). Alternatively, lifting the kettle from the base will
cause it to switch off automatically.
• If a lower temperature is required, leave the kettle on the base to cool. As the water cools,
the light ring will change colour according to the decreasing temperature.
CAUTION: If a lower temperature is desired, always place the kettle on the base and wait
for the water to cool. Do not attempt to pour the hot water out and refill with cold water
while the kettle is still hot as it may spit.
SWITCHING OFF / SLEEP MODE
• After 5 minutes of inactivity, the kettle will switch into sleep mode.
• Press any button to wake the kettle. All buttons will ash and the light ring will illuminate to
indicate the current temperature of the water.
• If reheating is required, press the desired temperature control button.
GENERAL
• Remove the kettle from the base before pouring.
• To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.
• Do not tilt the kettle backwards as water may seep into the control area.
• If this happens, empty any remaining water and allow the kettle to dry before further use –
place it in a warm, dry location for at least 12 hours.
• When you lift the kettle, you may see a little moisture on the base. This is the steam used
to switch the kettle off automatically, which then condenses and escapes via vents under
the kettle. This is normal.
• Always switch off and disconnect the appliance from the wall power outlet when not in use.
USING WITH INSUFFICIENT WATER
• Using the kettle with insufcient water can shorten the life of the element.
• If the kettle is accidently switched on when it does not contain sufcient water, a boil-dry
cut-out will switch the kettle off.
• Sit the kettle on a stable heat resistant surface until it has fully cooled down.
• Do not ll the kettle with water until it is cold, or it may spit.
CARE AND MAINTENANCE
• Check that the kettle is switched off by lifting the kettle from the base and replacing it.
• Switch the power off and remove the plug from the wall power outlet.
Loading ...
Loading ...
Loading ...