Loading ...
Loading ...
Loading ...
Umbau- und Montageanweisung
M.-Nr. 11245731 23 von 62
Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten. 17.03.2021
A Remove the screw caps from the lid.
A Loosen the 2 lid screws by approximately five turns. Press the screws in to release the retaining clips. See Fig. 2,
Item B.
A If one of the screws pops out, push it back in.
The locking clips in the lid will release from the side panels.
A Take off the lid; see Fig. 2, Item C.
A Only drill partway into the lid; do not drill all the way through it. Pre-drill with a 2mm bit; see Fig. 3, Item 1.
A Finish drilling with a 6mm bit. Holes should be 8mm deep; see Fig. 3, Item 2.
A If the lid was drilled all the way through, close the holes with silicone. Seal off the drilled holes from above
and underneath.
A Insert the M4x9 threaded bushings (1) flush with the top surface; see Fig. 4.
Tip
Screw in the M4x9 threaded bushings using, e.g., a 3.5mm Allen key, a 0.6x3.5mm slotted screw bit, or an HGO size 3
bit.
A Stick the 4 prepared spacers (1) on the underside of the frame, matching their holes to the drilled holes and making
sure that the guide pins on the spacers are positioned in the additional holes on the frame; see Fig. 5.
A Install and align the lid.
A Install the 2 rear foot holders and secure each with 1 M4x16 screw (1); see Fig. 6.
A Install the 2 front foot holders and secure each with 1 M4x16 screw (2); see Fig. 6.
A Install the lid.
A Insert new screw caps in the lid.
Stainless-steel lid
A Remove the protective film from the frame.
A Lay the frame on the lid flush with the back of the machine, level it and mark 8 holes (1); see Fig. 8.
A Loosen the 2 lid screws by approximately five turns. Press the screws in to release the retaining clips. See Fig. 9,
Item A.
A If one of the screws pops out, push it back in.
The locking clips in the lid will release from the side panels.
A Lift up the front of the lid by one hand's width and disconnect the ground wire from the inner right side.
A Take off the lid; see Fig. 9, Item B.
A Center-punch the lid.
A Pre-drill with a 2mm bit; see Fig. 10, Item 1.
A Finish drilling with a 3mm bit; see Fig. 10, Item 2.
A Remove any swarf (metal shavings).
A Stick the 4 seals (1) on the underside of the frame, matching their holes to the drilled holes; see Fig. 11.
A Install and align the lid.
A Install the 2 rear foot holders and secure with 4 M4x12 screws (1); see Fig. 12.
A Install the 2 front foot holders and secure with 4 M4x12 screws (2); see Fig. 12.
A Lay the lid on the machine, lift up the front by one hand's width and reconnect the ground wire on the inner
right side.
A Install the lid.
Loading ...
Loading ...
Loading ...