Loading ...
Loading ...
Loading ...
29
NOTE
• Steam may not necessarily be visible
inside drum during a steam wash cycle.
• Steam may not be present during entire
steam wash cycle.
CONTROLS AND SETTINGS
• Chocolate
Stain wash time is extended with
additional heating by boost heater.
StainSoak (600 series washer)
Similar to StainTreatII above with the added
feature of detergent/treatment
mixing with SmartBoost pump technology
before the Stain washing phase.
perfect steam
TM
(on select models)
Select this option to add approximately 20
minutes of tumbling in steam.
extra rinse (on select models)
Use this option when additional rinsing is
desired to remove excess dirt and detergent. It
is recommended for heavily soiled loads or if
household members have sensitive skin.
pure rinse (on select models)
Use this option to reduce detergent residues
and fragrances that can irritate skin which
rinses cleaner than the extra rinse cycle.
wrinkle release (on select models)
After the final spin, the washer will perform a
“dry” agitation to loosen the garments from
the side of the drum.
Wash cycle options
IMPORTANT
• If steam is selected, rinse temperatures
will be elevated.
• If the wash cycle is paused or
cancelled during a steam cycle, the
door will remain locked until it cools.
You may manually perform a rinse
& spin cycle to cool the internal
temperature sooner.
• During a steam cycle, steam exiting
from the rear vent of the washer is
normal and not cause for alarm.
extended refresh (on select models)
Select extended refresh if you will be unable
to remove the load right after the cycle is
complete. The washer recognizes the load
has sat too long and will do a rinse and spin
to keep the load fresh for up to 12 hours.
When you are ready to remove the load
during the extended refresh segment, you
must press cancel to end the cycle and
open the door.
PODS
®
(on select models)
Select this option when using a detergent
pack in a model equipped with a PODS
®
button (on select dispenser only). This option
will divert the flow of water to the detergent
pack compartment optimizing the detergent
pack performance.
Control options
control lock
To lock the controls between cycles, scroll to
the control lock option and press select. The
control lock icon will show on the LED display.
To unlock the controls scroll to the control
lock option again and press select. Use this
feature to reduce the likelihood of accidental
operation by children. Washer cycles will not
run when control lock is activated.
delay time
Use delay time
to delay the start of the
washing cycle from 30 minutes to 12 hours.
To turn on the delay time option, press
options to scroll to the delay time icon and
press select. Use the cycles button (300/400
models) or turn the cycle selector (500/600
models) to select the desired delay time and
press start. The delay time icon will illuminate
on the LED display to indicate the delay
time option is activated. The time will begin
counting down on the LED display once the
washer start/pause button has been pressed.
PODS
®
is a registered trademark of Procter & Gamble Company, Cincinnati OH, used under license by Electrolux.
Loading ...
Loading ...
Loading ...