Loading ...
Loading ...
Loading ...
24
Adapting the Blower for Recirculation
1. Remove and save the screw that holds the blower motor to microwave. Lift up the blower plate.
2. Carefully pull out the blower unit. The wires will extend far enough to allow you to adjust the
blower unit.
CAUTION: Do not pull or stretch the blower unit wiring, and take care to ensure all wires are not
pinched.
NOTE: The blower unit exhaust openings should match the exhaust openings on the rear of the
microwave oven.
5. Replace the blower plate back into its original position.
Mount the Microwave
For easier installation and personal safety, we recommend that two people install this microwave
oven.
CAUTION: Do not grip or use the handle during installation. Also, if filler blocks are not used,
damage to the microwave case may occur from over tightening screws.
NOTES:
• If your cabinet is metal, use the nylon grommet around the power cord hole to prevent the cutting
of the cord.
• We recommend using filler blocks if the cabinet front hangs below the cabinet bottom shelf.
• When mounting the microwave oven, thread power cord through hole in bottom of top cabinet.
Keep it tight throughout Step 1-3. Do not pinch the power cord or lift the oven by pulling cord.
Loading ...
Loading ...
Loading ...