Loading ...
Loading ...
Loading ...
8
Switch Housing
Fitter Plate
Fitter Plate
Screw
9-pin
Connector
Bulb
Finial
Finial Cap
Glass Bowl
Light Kit
Switch
Housing
Plug Button
Switch
Housing
Light Kit
Lock Washer
Hex Nut
ASSEMBLY INSTRUCTIONS
14
13. Install the E26-base LED bulbs into the sockets of the
light kit.
Important: Make sure you allow the bulbs and light kit to
cool before you replace the bulbs.
14. Remove the nial and nial cap from the threaded rod
at the bottom of the light kit. Lift the center hole in the
glass bowl over the threaded rod and secure with nial
cap and nial.
Skip to Step 17.
13
15
15. NO LIGHT KIT INSTALLATION OPTIONAL
To install the fan without the light kit, remove the
preassembled hex nut and lock washer from the threaded
rod inside the switch housing. Disconnect the single-pin
connectors inside the switch housing. Then, remove the
light kit from the switch housing. Insert the plug button
from the hardware kit into the center hole of the switch
housing.
16
16. NO LIGHT KIT INSTALLATION CONT’D
Remove the three tter plate screws from the tter plate.
Connect the 9-pin connector from the fan to the 9-pin
connector from the swith housing. Then, install the switch
housing to the tter plate with the three tter plate
screws.
Loading ...
Loading ...
Loading ...