Loading ...
Loading ...
Loading ...
@
Cooktop
To prevent the cooktop from discoloring or
staining:
CHeancooktop after each use.
Wipe acidic or sugary' spills as soon as the cooktop has
_ cooHedas these spills may discoHorthe
__ UnHikea range with standard gas burners,
this cooktop does not Hilt-up nor is it
removaMe. Do not attempt to lift the
%®_,' eooktop for arty reason°
Burner Grates
The grates must be propedy positioned before
cooking. Improper installation of the grates may
result in chipping of the cooktop.
Do not operate the burners without a pan on the
grate.
The grate's porcelain finish may chip without
a pan to absorb the heat from the burner
flame.
Although the burner grates are durable, they will gradually
lose their shine and/or discolor, due to the high temperatures
of the gas flame.
Seamed Burners
The sealed burners of your range are secured to the cooktop
and are not designed to be removed. Since the burners are
sealed into the cooktop, boilovers or spills will not seep
underneath the cooktop=
However, the burner should be cleaned after each use= (See
page 21 for cleaning directions=_)
High Performance Burner
(12,000 BTU*
There is one high speed burner on your range, located in the
right front position. This burner offers higher speed cooking
that can be used to quickly bring water to a boil and for large-
quantity cooking.
Simmer Burner
This burner is located in the left rear position. The simmer
burner offers a lower BTU* flame for delicate sauces or
melting chocolate.
BTUratings will vary when using LP gas,
A properly adjusted burner with clean ports will light
within a few seconds. If using natural gas, the flame
will be blue with a deeper blue inner cone.
If the burner flame is yellow or is noisy, the air/gas
mixture may be incorrect. Contact a service technician
to adjust. (Adjustments are not covered by the war-
ranty.)
With LPgas, slight yellow tips on the flames are
acceptable. This is normal and adjustment is not
necessary'.
" With some types of gas, you may hear a "popping"
sound when the surface burner is turned off. This is a
normal operating sound of the burner.
" If the control knob is turned very' quickly from High to
Low, the flame may go out, particularly if the burner is
cold. If this occurs, turn the knob to the OFF position,
wait several seconds and relight the burner.
" The flame should be adjusted so it does not extend
beyond the edge of the pan.
6
Loading ...
Loading ...
Loading ...